For example, the 034B-ET model designates the sensor as a 034B for an ET107 system. If a cable terminates with a special connector for a unique system, the end of the model number designates which system. For example, the 034B-ET model has a description of “Met One Wind Set for ET Station, 67 inch Cable.” Products with a set cable length terminate, as a default, with pigtails. The cable length is listed at the end of the Description field in the product’s Ordering information. If a sensor does not have an –L or other –LX designation after the main model number, the sensor has a set cable length. An –LQ model has a user-specified cable length for connection to a RAWS-P weather station.An –LC model has a user-specified cable length for connection to an ET107, CS110, or retired Metdata1.
If a sensor is listed as an –LX model (where “X” is some other character), that sensor’s cable has a user-specified length, but it terminates with a specific connector for a unique system: Most Campbell Scientific sensors are available as an –L, which indicates a user-specified cable length. Wind speed measurements can be taken and processed with any of the data loggers. The 03101 is read by the PulseCount Instruction in CRBasic and by Instruction 3 (Pulse Count) in Edlog. The 03101 uses one pulse count channel on the data logger. Data loggers compatible with the LLAC4 are the CR200(X)-series (ac signal ≤1 kHz only), CR800, CR850, CR1000, CR3000, and CR5000. The LLAC4 allows data logger control ports to read the anemometer’s ac signals instead of using pulse channels. For this application, the LLAC4 4-channel Low Level AC Conversion Module can be used to increase the number of anemometers measured by one data logger. Wind Profile StudiesĪn ideal application for the Wind Sentry is wind profile studies.
The 03101 can also be mounted to the top of a CM106B or a stainless-steel tripod via the CM216. IPS threaded pipe, which mounts to a crossarm via a CM220 mount or 1049 Nu-Rail fitting. The 03101 anemometer is supplied with a galvanized 10-in.-long x ¾-in. Additional Compatibility Information Mounting
0 kommentar(er)
